MODINE DFG Mild Temperature Thermostat Installation Guide
INSTALLATION & SUBMITTAL DATA - MILD TEMPERATURE THERMOSTAT
Wiring
Adjustment
Installation of wiring must conform with local building codes,
or in the absence of local codes, of the National Electric
Code ANSI/NFPA 70 - Latest Edition. Unit must be electrically
grounded in conformance to this code. In Canada, wiring must
comply with CSA C22.1, Part 1, Electrical Code.
The control is supplied with an external range adjustment and
screwdriver slot as shown in Figure 2.2. Dial settings indicate
the cutout setting.
Figure 2.2 - Dimensions of A19AAF-12
(All dimensions in inches)
Use the terminal screws furnished with the control. Substitution
of other screws may cause problems in making proper
connections.
0.38
2.12
1.94
Wiring Diagram Selection
•
For duct furnaces (non-factory supplied blower) refer
Figure 2.1 for wiring.
3.00
2
3
•
For deviations to these wiring diagrams or the job specific
wiring diagrams: consult the factory.
W
B
4.38
R
H/W
Figure 2.1 - Typical Duct Furnace Wiring
Red to Blue closes on temperature decrease,
Red to Yellow closes on temperature increase.
1
MILD TERMPERATURE
GROUND
SCREW
Y
THERMOSTAT
FRONT
1.50
SIDE
7
8
R
B
Ø
0.25
DENOTES DUCT FURNACE TERMINALS
DOTTED LINES REFER TO FIELD WIRING
2.94
0.75
BACK
Modine Manufacturing Company has a continuous product improvement program, and therefore reserves the right to change design and specifications without notice.
Modine Manufacturing Company • 1500 DeKoven Avenue • Racine, Wisconsin, USA 53403-2552 • Phone: 1.800.828.4328
© 2024 Modine Manufacturing Company
5-583.3
| General | Details |
|---|---|
| Name | MODINE DFG Mild Temperature Thermostat Installation Guide |
| Make | Modine |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.1 MB |

MODINE 5-580.4 Programmable Room Thermostat Installation Guide















