Home > HyperStat > HyperStat 7C-HS-C2W-X Wall Mount Thermostat Installation Guide

HyperStat 7C-HS-C2W-X Wall Mount Thermostat Installation Guide

1. HyperStat Interface - Conventional  
2. HyperStat Main  
5. Rubber cover 2  
6. Gang Box  
3. Allen head screws  
4. Rubber cover 1  
7. PHP screws  
8. External Antenna  
1.  
Place the HyperStat Interface-Conventional and the back plate (only if the gang box is  
fixed vertically) on the gang box such that the back plate covers the gang box and fix  
these two items to the wall gang box with the PHP screws provided in the box.  
2. Now align the HyperStat main to lock onto the HyperStat Interface-Conventional.  
3. Use the Allen head screws to make this entire setup tamper-proof.  
4. Rubber covers 1 and 2 must be fixed to cover the programming pins.  
5. Connect the antenna to the device as shown in the above figure. Rotate the antenna  
clockwise to lock it in place.  
D
I
S
-
A
S
S
E
M
B
L
I
N
G
1.  
If the HyperStat is mounted on the wall, hold the front plastic with both hands and pull it  
away from the wall.  
2. If you are holding the HyperStat in your hands, insert a flat head screwdriver in the notch  
provided (marked by the two arrows shown in the image) between the front and back  
plastic and twist to separate them.  
For more information, contact your local Carrier Controls Expert  
©2023 Carrier. All Rights Reserved. Cat. No. 11-808-959-01  
GeneralDetails
NameHyperStat 7C-HS-C2W-X Wall Mount Thermostat Installation Guide
MakeHyperStat
LanguageEnglish
FiletypePDF (Download)
File size0.15 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

HyperStat 7C-HS-C2W-X Wall Mount Thermostat Installation Guide