Home > Coleman > Coleman 9420-381 Digital Wall Thermostat Instruction Manual

Coleman 9420-381 Digital Wall Thermostat Instruction Manual

Wire Labeling and Connectors  
The labeling of the inputs/outputs of the  
thermostat can be found on the rear of the  
thermostat.  
Label on  
Thermostat  
Definiꢀon  
R
B
Voltage input (+12V)  
Ground  
Refer to the table below for labels and definiꢀons.  
Y
Compressor output  
Fan high output  
Fan low output  
Gas heat output  
Elec heat output1  
External sensor input  
GH  
GL  
W
WHP  
SENS  
1 WHP Connecꢀon for Electric heat output is used  
for Heat Pump or the strip heat accessory for the  
A/C.  
The connectors of the thermostat can accept 20  
AWG solid wire. To insert a wire, strip the wire to  
the appropriate length (5/16”). The stripped length  
can be checked by using the strip gage on the back  
of the thermostat. Press the stripped wire into the  
connector unꢀl the iniꢀal resistance is overcome.  
Lightly tug on the wire to ensure the connecꢀon is  
solid.  
To remove a wire, press down on the connector’s  
tab with a screwdriver and pull wire verꢀcally. It  
won't take much force to pull the wire to remove it.  
If the thermostat had wires previously inserted into  
one of the connectors, it is recommended to use  
the same gauge wire in that posiꢀon or a larger  
(diameter) gauge wire.  
Thermostats equipped with plugs (9420-382):  
Reference illustraꢀon below for connectors.  
If the wires are cut to remove the plugs, the wires must be spliced (or terminated) following the electrical  
code and using good workmanship pracꢀces.  
GeneralDetails
NameColeman 9420-381 Digital Wall Thermostat Instruction Manual
MakeColeman
LanguageEnglish
FiletypePDF (Download)
File size0.19 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

Coleman 9420-381 Digital Wall Thermostat Instruction Manual