Coleman 9420-381 Digital Wall Thermostat Instruction Manual
Installaꢀon
2. Affix the mounꢀng plate to the wall
using two screws. Wall anchors are
included if needed to secure the
mounꢀng plate to the wall.
ELECTRICAL SHOCK HAZARD – Turn off power
at the main service panel by removing the
fuse or switching the appropriate circuit
breaker to the OFF posiꢀon before removing
the exisꢀng thermostat (if applicable).
3. Wire the thermostat to the
motorcoach:
A. Thermostat Locaꢀon
Refer to the secꢀon “Wire Labeling
and Connectors” secꢀon in this
manual for wiring the thermostat.
The thermostat is a sensiꢀve electronic
instrument. For accurate temperature control
and comfort, the following should be
considered:
Refer to the secꢀon “Dip Switches”
secꢀon in this manual to set the dip
switches to the appropriate seꢁngs
for the equipment installed on the
coach.
1. Locate the thermostat on an inside wall
about five feet above the floor. Pick a dry
area where the air circulaꢀon is good.
4. Place the thermostat on the mounꢀng
plate and gently slide the thermostat
down to lock the thermostat onto the
mounꢀng plate.
2. Do not install the thermostat where
there are unusual heaꢀng condiꢀons
such as direct sunlight, near heat
producing appliances (TV, radio , wall
lamp, etc.), or a furnace or air
5. Turn on the power to the thermostat.
condiꢀoner supply register.
REFER TO THE OPERATION GUIDE FOR
THERMOSTAT DISPLAY INFORMATION &
THERMOSTAT OPERATION
3. The Thermostat must be installed in a
verꢀcal posiꢀon.
B. Installing the Thermostat
1. Place the thermostat mounꢀng plate
against the wall where the thermostat
will be mounted orienꢀng it as shown
below.
| General | Details |
|---|---|
| Name | Coleman 9420-381 Digital Wall Thermostat Instruction Manual |
| Make | Coleman |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.19 MB |





















