Home > Braebur > Braebur 1230 Non Programmable Thermostat Instruction Manual

Braebur 1230 Non Programmable Thermostat Instruction Manual

2
INSTALLATION  
Provide Power  
C
Batteries Installed as Shown  
24VAC Power Terminal (C)  
• Battery Power - Insert the 2 supplied “AA” type alkaline batteries into the battery compartment located  
in the rear housing of the thermostat. Make sure to position the Positive (+) and Negative (-) sides of the  
batteries correctly with the +/- symbols in the battery compartment.  
Optional 24 Volt AC power - Connect the common side of the transformer to the C terminal on the  
thermostat sub-base. In dual transformer installations, the transformer common must come from the  
cooling transformer.  
Set Installer Switches  
The Installer switches are located on the back of the thermostat and must be  
properly configured for this thermostat to operate properly.  
Factory Setting  
Default Options Comments  
Switch  
CONV Select for conventional systems  
CONV / HP CONV  
HG / HE HG  
HP  
HG  
HE  
Select for heat pump systems  
Select for gas heat  
Select for electric heat  
Attach to Thermostat Sub-Base  
Once you complete the wiring in Section 3, attach  
thermostat to sub-base and then configure the  
Installer Settings in Section 5.  
1) Line up the thermostat body with the sub-base.  
2) Carefully push the thermostat body against the  
sub-base until it snaps in place.  
UP  
NOTE: This thermostat ships configured as a  
conventional (CONV) thermostat.  
3
Installer Manual  
GeneralDetails
NameBraebur 1230 Non Programmable Thermostat Instruction Manual
MakeBraebur
LanguageEnglish
FiletypePDF (Download)
File size0.24 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

Braebur 1230 Non Programmable Thermostat Instruction Manual