Honeywell RTH9580 Wi-Fi Color Touchscreen Programmable Thermostat User Guide
1.6 Connect wires
Note: The wiring for your application
might be different than the wiring
shown below.
Important! C wire is required and
is the power source. Without a C wire,
your thermostat will not power up.
View the Alternate Wiring videos
at wifithermostat.com/videos
Terminal release
1.6a Starting with the C Wire, match
the sticky tag on the wire to the
terminal labels.
C
W-
O/B
W
C
Y
Y
G
K
Rc
R
G
R
W2-
Aux/E
1.6b Straighten wire and gently slide
into terminal hole until it clicks
into place. (If you need to
Y2
L
remove a wire, use a pen tip to
press the terminal release and
then pull the wire out.)
EXAMPLE WIRING
Yours may look different
Note: Refer to the wiring picture
you took in Step 1.2.
Remove jumper loop ONLY if
you have both R and Rc wires.
Tip: To make it easier to slide the
wire into place, use a pen tip to
hold down the terminal release.
Labels don’t match or have
heat pump system?
See User Guide.
7
| General | Details |
|---|---|
| Name | Honeywell RTH9580 Wi-Fi Color Touchscreen Programmable Thermostat User Guide |
| Make | Honeywell |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.34 MB |

Honeywell T6 Pro Programmable Thermostat User Manual

Honeywell D1-528 Direct Thermostat Installation Guide

Honeywell FocusPRO P200 Programmable Thermostat User Guide

Honeywell RCHT8610WF Series Smart Thermostat Installation Guide

Honeywell T9 Smart Thermostat Installation Guide

Honeywell TH2320WF4011 FocusPRO Smart S200 Series Thermostat User Guide

Honeywell TL116A Thermostat Installation Guide

T10 Pro Smart Thermostat with Redlink Room Sensor

Honeywell TH6320WF2003 Lyric T6 Pro Wi-Fi Programmable Thermostat User Guide

Honeywell Smart Color Touchscreen Programmable Thermostat RTH9590 User Manual

































