Home > Thermogroup > Thermogroup 5255 Manual Thermostat Installation Guide

Thermogroup 5255 Manual Thermostat Installation Guide

Installation & User Guide  
5255 Manual Thermostat  
Operating the Unit  
Use the On & Off switch to turn the unit on and off. The LED positioned on the front of the 5255  
will light up when the floor heating is heating (i.e. The floor temperature is below the desired set  
temperature). Turn the temperature dial to select a desired temperature. Do not turn on the  
Underfloor Heating system until all adhesives and levelling compounds have fully cured.  
Consult manufacturer guidelines for curing times.  
Setting the min & max temperatures  
Behind the knob, there are red and blue locking rings held in position by a screw. To set the  
limitations, loosen the screw (Fig 1 - C) and adjust the red limit ring to the desired maximum, set  
the blue ring to the desired minimum temperature, then retighten the screw. The knob must be  
re-installed exactly as it was removed. Please note Australian regulations set the maximum running  
temperature for Underfloor Heating at 28ºC.  
Fig. 1  
A. Temperature Knob  
B. Frame and Cover Screw (Captive Screw)  
C. Limitations Screw  
SUPPLY VOLTAGE MAX LOAD  
IP RATING  
WARRANTY  
UNIT SIZE  
TEMP RANGE  
W84 x H115 x D50mm  
(28mm in wall)  
230~240V  
16A  
IP20  
3 Years  
10°C to 50°C  
1300 368 631  
GeneralDetails
NameThermogroup 5255 Manual Thermostat Installation Guide
MakeThermogroup
LanguageEnglish
FiletypePDF (Download)
File size0.05 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
Thermogroup Thermotouch 4.3dC Dual Control Thermostat Installation Guide
Thermogroup Thermotouch 4.3dC Dual Control Thermostat Installation Guide

Thermogroup 5255 Manual Thermostat Installation Guide