Home > PEREL > PEREL CTH407 NON-PROGRAMMABLE THERMOSTAT User Manual

PEREL CTH407 NON-PROGRAMMABLE THERMOSTAT User Manual

CTH407  
2. Remove the front cover using an appropriate screwdriver.  
3. Mount the thermostat on a flat surface. Drill two 6 mm holes and  
insert a nylon anchor plug in each hole. Drill two 2.6 mm holes  
when mounting the thermostat on a wooden surface.  
4. Wire the thermostat. The thermostat is designed for maximum  
230 V~, 7 A. Never exceed these limits!  
From left to right, the connection terminals are: neutral  
input (N in), live input (L in) and live output (L out). Use wires  
with diameter of 1.0-2.5 mm² and connect accordingly.  
5. Replace the front cover and switch on the mains power supply.  
The working LED [2] will turn blue to indicate proper connection.  
6. Operation  
6.1  
Setting the Temperature  
1. Slide the on-off switch [1] to the HEAT position. The thermostat  
will switch on and enter the temperature control status.  
2. Turn the temperature SET knob [4] to the desired room  
temperature. The working LED [2] will light.  
3. Slide the on-off switch to the OFF position to switch off the  
thermostat.  
Note  
Due to the built-in delay, the thermostat will not respond  
immediately when the temperature setting is changed.  
6.2  
Setting the Eco Mode  
The eco mode is an energy-saving mode, which temperature is 5 °C  
lower than the set temperature.  
How to set the eco mode:  
V. 02 22/06/2021  
5
©Velleman nv  
GeneralDetails
NamePEREL CTH407 NON-PROGRAMMABLE THERMOSTAT User Manual
MakePEREL
LanguageEnglish
FiletypePDF (Download)
File size0.39 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...

PEREL CTH407 NON-PROGRAMMABLE THERMOSTAT User Manual