Home > finder > finder 1C.B1 Bliss2 Smart Thermostat User Manual

finder 1C.B1 Bliss2 Smart Thermostat User Manual

EASY INSTALLATION  
1
TECHNICAL SPECIFICATION  
FIXING BASE TO WALL  
ELECTRICAL CONNECTIONS  
Power supply: 3x1.5 V alkaline batteries type AAA - LR03  
Temperature adjustment: (+5…+37)°C  
Resolution: 0.1°C  
First, detach thermostat from its base by inserting two fingers into  
the central rear hole and, with the other hand, pull the front of the  
thermostat towards you.  
To make the connections, first refer to instructions for your heating  
system (pump, valve, boiler, etc.), then remove the terminal cover  
and connect the appropriate wires to terminals 6 (COM) and 7 (NO)  
of the Smart Bliss2 thermostat.  
Degree of protection: IP20  
FIXING BASE  
Output: 5 A 250 V AC changeover volt-free contact  
Mounting: Wall  
Secure the Smart Bliss2 thermostat base to the wall using the screws  
included in the package. When fixing, be careful not to over-tighten the  
screws to avoid damaging the base.  
01C.02.8.230.0500  
INSTALLATION NOTES  
SAFETY REQUIREMENTS  
The installation and assembly of electrical equipment must be  
performed by experienced personnel. Before connecting the  
thermostat, make sure that the load (pump, valve, boiler, etc.) is not  
powered and that it falls within the thermostat’s contact rating.  
POSITIONING  
Install the thermostat away from heat sources (radiators, direct  
sunlight, kitchens), away from doors/windows, and mount  
approximately 1.5 meters above floor level.  
NC  
C
NO  
Type 01C.02.8.230.0500: OPTIONAL power supply  
Using the external power supply, the batteries MUST be removed.  
GeneralDetails
Namefinder 1C.B1 Bliss2 Smart Thermostat User Manual
Makefinder
LanguageEnglish
FiletypePDF (Download)
File size1.29 MB
Download PDF
1 Star2 Stars3 Stars4 Stars5 Stars (1 votes, average: 5.00 out of 5)
Loading...
finder 7T Series Enclosure Thermostat User Guide
finder 7T Series Enclosure Thermostat User Guide

finder 1C.B1 Bliss2 Smart Thermostat User Manual