Guangzhou XR-01 Central Air Conditioning Thermostat User Manual
3.1 Installation and wiring instructions
Installation location: The installation location should be about 1.4m above the ground, avoiding
direct sunlight, shelter from wind, and away from heat sources. It should be a representative
location of the room temperature.
Tools required for wiring installation: wire strippers, screwdrivers, and other wiring tools.
Installation personnel: The installer of this product must be a professional technician with
experience in electrical equipment installation and operation. Under no circumstances should there
be personnel without professional qualifications or training to operate it.
Installation wiring requirements: Cut off the power supply during installation. Configure a
power switch to cut off power when not heating. When wiring, it is necessary to follow the
relevant specifications and standards for wire connectors to ensure that the wire connectors do not
ignite, short circuit, or have poor contact, in order to prevent accidents. Non professionals are
prohibited from wiring and installing the central air conditioning controller.
3.2 Install wiring
The Xinrui XR-01 is powered by 100-240V AC mains electricity. Please confirm that the circuit
system is in a power-off state before connecting to Xinrui. The installation steps of temperature
controller XR-01 are as follows:
Step one, use a screwdriver to open the thermostat.
Figure 5 Schematic diagram of disassembling the main control board
Use a Phillips screwdriver to extend along the slope to the slot and remove the bottom plate
of the LCD main control panel.
Step two, connect the wires.
8
| General | Details |
|---|---|
| Name | Guangzhou XR-01 Central Air Conditioning Thermostat User Manual |
| Make | GUANGZHOU |
| Language | English |
| Filetype | PDF (Download) |
| File size | 0.33 MB |



























